Reasons to Trim or Prune a Tree in Kansas city

Trees in Kansas City are generally trimmed for one of three purposes: aesthetics, safety or health. For example:

• Kansas City Aesthetics – Pruning a tree effectively helps to maintain its shape and appearance. However, you shouldn’t try to impose an unnatural shape or size on a tree. The amount of trimming and pruning that will be needed could seriously damage it.
• Kansas City Safety – Dead or broken branches and limbs can fall off at any time, which is a serious safety hazard. If the branches of a tree obstruct your vision while driving, they should be trimmed away. Finally, tree limbs and branches occasionally grow too close to utility lines. Contact the utility company to handle such issues.
• Kansas City Health – It is sometimes possible to save an infected tree by strategically pruning away affected branches and limbs. Thinning the crown of a tree improves airflow, which can be very beneficial. If branches are crossing or rubbing together, they should be trimmed so that they don’t fall unexpectedly.

General Tree Trimming Tips in Kansas City

• It’s almost always best to trim or prune a tree during its dormant season. Although you can technically prune a pine tree at any time, it is still better to do so when it is dormant. The only exception is when a hazard exists.
• Be conscientious about the size of the branch that you are going to remove. If it is less than five centimeters in diameter, removing it is fine. If it is between five and 10 centimeters in diameter, you might not want to do it. If it is more than 10 centimeters in diameter, you should only do so if you have a really good reason.
• Only trim branches that have weak, V-shaped, narrow angles. Retain branches that have strong, U-shaped angles.

<li

Lateral branches should be between one-half and three-quarters the diameter of the stem at point of attachment. Otherwise, they should be removed.

• When pruning is complete, the ratio of living crown to tree height should be two-thirds.
• Try to prune away branches when they are young. They are much easier to manage at that point, and the risk of leaving nasty scars is much lower.
• Don’t trim a branch too close or too long. You shouldn’t leave a large stub or remove the branch collar.

Tree Pruning Tips in Kansas City

The following tips and techniques will help guide you if you’re planning on pruning a tree or if you just want to educate yourself about typical tree trimming care and maintenance techniques.

Crown Thinning

If you need to thin the crown of a tree, you should keep the following tips and techniques in mind:

• Keep lateral branches as evenly spaced as possible, especially on young trees.
• Prune away branches that cross other branches or run against them.
• Never remove more than one-fourth of a living crown at once. If you need to remove more than that, spread it out over a number of years.

Crown Raising

• To provide clearance for pedestrians and for other reasons, you can raise the crown by carefully pruning the tree. Maintain live branches on at least two-thirds of a tree’s height. If you remove too many branches near the bottom half, the tree may not be able to develop a strong stem.

Crown Reduction

• If you need to remove more than half of the foliage from a branch, just remove the whole branch.
• Only reduce the crown of a tree if it’s really necessary. Prune lateral branches that are at least one-third of the diameter of the stem that needs to be removed.

Tree Trimming Techniques in Kansas City

Here are a few tree pruning techniques to keep in mind:

• Before making a cut, look for the branch collar, which grows from the stem tissue at the bottom base of the branch. Look for the branch ridge, which is on the upper surface and is parallel to the branch angle at the stem.
• Always cut outside the branch bark ridge and angle your cut down and away from the stem. Take care not to injure the branch collar.
• Use the same technique to prune dead branches and living branches.
• If a stem is too long, use the three-cut technique: Make a notch on the side of the stem that faces away from the branch that’s being retained; make the second cut inside the crotch of the branch and above the branch ridge; the third cut will remove the stub by cutting through the stem parallel to the branch bark ridge.

Keep these tricks and techniques from this tree pruning guide in mind before taking on the task of pruning and trimming your trees.

we are serving the Kansas City. Overland Park, Johnson County Kansas surroundings. Call now!